QuickChange V2 IRS Drift 930 CV Flange

Diversified Machine Industries made this QuickChange V2 IRS Drift 930 CV Flange (XR-420I V2) rear axle for drift racers and high-performance IRS builds that need fast, tool-free axle swaps between track sessions. The quick-change system lets pit crews swap ratios or replace a damaged shaft in minutes instead of hours. It measures 16 x 14 x 26 inches and weighs 111 lbs.

At the core is a 930 CV flange design that sends power to the rear wheels with very little vibration, even at the extreme steering angles used in drifting. The V2 version improves the locking system, removing any play that could cause noise or uneven tire wear during long sideways runs. The independent rear suspension geometry stays fully intact, keeping camber and toe consistent.

Drift teams and track builders will get the most from this axle, especially those running platforms that accept an IRS conversion. A professional alignment is recommended after installation to get the full performance from this DMI unit. Whether you are building a dedicated competition car or a dual-purpose street and track vehicle, the XR-420I V2 brings fast pit stops and race-day reliability to the rear axle.